Hello there! Daniel West, here with a fun project that should take just about 15 minutes to complete. The payoff ends up way better than the investment.
The Apen Leaves Die takes the prize in this ensemble. Save 15% off your purchase with code DANIELW15. I used these LDRS Creative supplies for this project.
To begin, I die cut a frame using two Diagonal Stitched Layered Frames dies and back it with double thick foam tape.
Next, I blended some ink onto the back panel with a brush in a gradient and dropped water on it.
Then, I die cut the Aspen Leaves Die out of white cardstock and vellum.
After that, I stamped and die cut the sentiment. Then, I melted some clear embossing powder over the stop of it.
Finally, I just stacked it all together and glued down some of the leaves and the sentiment to keep them in place.
I hope you will give this little beauty a try. You could make a ton of them in no time.
Thank you for joining me today and have a wonderful weekend!